Advance Materials ManufacturingProcesses and Braking Assembly

Ya’qub Adamu

Abstract


The brake assembly basically describes the in-plan vibration of a slider-mass which is driven around the surface of flexible disc, are investigated. The slider has the flexibility and damping in the circumferential (in-plane) and transverse directions. The numerous results show that initial braking pressure and the rotating speed of the drive point can drive the system into instability. While the rigidity and damping of the disc, and transverse stiffness and damping of the slider tend to suppress the vibrations. The motivation of this work is the understanding of the instability and in the physical systems such as car brake discs where there vibrations induced by non-smooth dry friction forces. The forming other components are: calipers and pads, all these makes the brake assembly. (Ashby, M F, Jones, D R H, 1996) The paper focuses on materials and the behaviors based on the following: *Operational requirement and service condition; *Design requirement; *How does this material affect current production method?; *Provide an alternative material to be used as the case may be; *Indicate a feasibility production route that could be considered for the alternative material proposed above

DOI: 10.5901/ajis.2014.v3n7p16


Full Text: PDF

Licenza Creative Commons
This work is licensed under Creative Commons Attribution 3.0 License.

Academic Journal of Interdisciplinary Studies ISSN 2281 3993(Print) ISSN 2281-4612(Online)

Copyright © MCSER-Mediterranean Center of Social and Educational Research

To make sure that you can receive messages from us, please add the 'mcser.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders..